Siding Trimming

Here are the options to control how the siding elements are going to be trimmed:

Weinmann WUP Exporter. Advanced Setup window

Table

---

• Operation – provides a number for reference to use with the preview image.

---

• Trimming – provides a description of the processing area.

---

• Perform – turns off operation for the specified area.

---

• Control Code – machine-specific code to control and customize various aspects of how the processing is supposed to be performed.

---

• Command Code – lets you choose what processing command code is supposed to be used:

  • PSG (default) – sawing process.

  • PAF – countersinking process.

---

• Cut Direction – lets you choose the direction the saw travels on specific cuts.

  Note: Only available for horizontal siding elements and left/right sides of the opening

---

• Tilt Angle – lets you choose the tilt of the saw, resulting in angled cuts. 0° results in a square cut.

---

• Blocked Area -

---

• Cut Start Offset – this lets you apply offsets to the start of cut lines to avoid overcutting or undercutting. Use negative values to shorten cut lines, and positive for lengthening.

---

• Cut End Offset – this lets you apply offsets to the end of cut lines to avoid overcut or undercut. Use negative values to shorten cut lines, and positive for lengthening.

---

Other Options

---

• Merge Blocked Areas -