Configuration Settings
Framing Configuration may be found in two locations:
or:
Configuration Settings
Use for all Vertical/Horizontal Framing Elements (except Openings) – if ON, then the selected Stud and Plate families will be used for other framing elements, like connections, bridgings, noggings, etc. without an option to change it to a custom family.
Main Type of Studs (or Plates) – pick a family and type for the Studs or Plates.
Sample stud and plate families that come with Wall+:
Metric Stud – M_WF Stud.rfa
Metric Plate – M_WF Plate.rfa
Imperial Stud – I_WF Stud.rfa
Imperial Plate – I_WF Plate.rfa
Do not use any other families! You can use other families only in special cases. Contact us (https://helpdesk.agacad.com/support/tickets/new).
Width (b) – shows the width, b, parameter value of the selected family type.
Depth (h, d) – shows the depth, h or d, parameter value of the selected family type.
Define Depth (h, d) by Layer Thickness – the software will create a new type for the selected family and change the depth value to the wall layer thickness so that the frames will fit the layer in the wall.
Wall Frame Panels – if ON, then wall frames are assembled in factory; if OFF – assembled on-site.
Last updated