Create Piggyback Roof Truss Type From Model Lines
Last updated
Was this helpful?
Last updated
Was this helpful?
Draw a model line and set roof cutoff level to desired height
Select a model line and run Create Roof Truss Type from Model Lines
Name new truss type - select OK and wait for truss to be generated
Select Model line and run Create Section View by Model Line
Set Roof Cutting Level to None
Draw new model line for piggyback truss
Select a model line and run Create Piggyback Roof Truss Type from Model Lines
Use Truss Builder to design new truss - select OK
Select Group, write new truss family name and fill values of other parameters
New truss will be created in the place of model line. Section view will be automatically deleted
Edit type parameter of a new created piggy back truss - Truss Offset
