Link Wall

Links Rebar Configuration with selected wall layer. Choose which configuration should be used on each wall layer.

1. Create Rebar Configuration.

2. Select wall and click Link Wall.

1. In the following dialog window assign configuration for each layer.

1. Add checkbox to layers which should be reinforced.

Now you can use the Create Rebar command for this wall type which already has configurations assigned through the Wall Link.

---

The same steps can be performed through the configuration window.

1. Open the configuration window.

2. Open the Link Wall tab.

3. Assign the configuration to the wall.

4. Save changes for the configurations and the Link Wall command using the Save button at the bottom of the configuration window.

1. Either use the Create Rebar command or the Apply feature, if needed.

---

Difference between Save (1) and Save (2) (for clearance – see image below):

• Save (1): Saves only the configuration.

• Save (2): Saves both the configuration and any changes made within the Link Wall tab.