Configuration Settings
Last updated
Was this helpful?
Last updated
Was this helpful?
Framing Configuration may be found in two locations:
or:
https://helpdesk.agacad.com/support/solutions/articles/44001798134-framing-configuration-common-settings-configuration-settings 1/2 1/13/23, 10:52 AM FRAMING CONFIGURATION – Common Settings – Configuration Settings : AGACAD
Use for all Framing Elements (except Openings) – if ON, then the selected Joist and Rim Joist families will be used for other framing elements, like connections, bridgings, noggings, etc. without an option to change it to a custom family.
Main Type of Joists (or Rim Joists) – pick a family and type for the Joist or Rim Joist.
Use sample families which comes together with the software. Do not use any other families!
Width (b) – shows the width, b, parameter value of the selected family type.
Depth (h, d) – shows the depth, h or d, parameter value of the selected family type.
Define Depth (h, d) by Layer Thickness – the software will create a new type for the selected family and change the depth value to the roof layer thickness so that the frames will fit the layer in the wall.
Roof Frame Panels – if ON, then roof frames are assembled in factory; if OFF – assembled on-site.
https://helpdesk.agacad.com/support/solutions/articles/44001798134-framing-configuration-common-settings-configuration-settings 2/2
You can use other families only in special cases. .
Preview